Fine WoodworkingFine Woodworking from Growing LifestyleReaders Gallery From Fw 183- (Found July 2, 2008 ) Lewis's blanket chest is a reproduction of a black unicorn chest from Bern Township, Berks County, Pa., ca. 1765-1810. ...http://www.growinglifestyle.com/us/h201/a31053421.html Make Clean Cuts On The Tablesaw- (Found July 2, 2008 ) Tearout is most likely to occur on the underside of the workpiece as well as on the back edge and back corners (drawing ...http://www.growinglifestyle.com/us/h201/a26039981.html Prevent Tearout In Figured Wood- (Found July 2, 2008 ) Feed your wood into the planer at an angle. Even a slight angle will make a difference. Angling the board allows the ...http://www.growinglifestyle.com/us/h201/a26039982.html Attaching Tabletops- (Found July 2, 2008 ) The clips are installed after the base has been assembled. Place one end of the clip into the groove and screw the ...http://www.growinglifestyle.com/us/h201/a26039983.html Shaping Tapered Legs- (Found July 2, 2008 ) For complete plans and instructions for building this table, inspired by 1950s-era Scandinavian style, read Mario's ...http://www.growinglifestyle.com/us/h201/a26039984.html Dewalt Beefs Up Its 5-In. Sanders- (Found July 2, 2008 ) DeWalt (www.dewalt.com) has released a more robust line of 5-in. random-orbit sanders. I test-drove the D26453K, a ...http://www.growinglifestyle.com/us/h201/a26039985.html Readers Gallery From Fw 182- (Found July 2, 2008 ) These dazzling tilt-top tables (each 40 in. dia. by 32 in. tall) are based on an original made for the eldest daughter ...http://www.growinglifestyle.com/us/h201/a26039986.html Sharpening Curved Scrapers- (Found July 2, 2008 ) A curved scraper is sharpened in much the same way as a flat scraper is. It takes a couple of tools to handle the ...http://www.growinglifestyle.com/us/h201/a31053414.html Marking Your Work- (Found July 2, 2008 ) Before cutting your joints, it pays to make a few marks on your stock to keep things in order and keep track of parts. ...http://www.growinglifestyle.com/us/h201/a31053415.html Fitting A Twisted Drawer- (Found July 2, 2008 ) It is best to remove as much of the twist as possible from the bottom of one drawer side before the final-fitting stage. ...http://www.growinglifestyle.com/us/h201/a31053416.html |